Question

[Texas94fs]

I've got spoked rims, y'all have a guy that can lace those after the hubs and rims get PC? Also, engine covers, no coating would get on the inside of them correct? Just don't want to have to worry about the motor sealing back up.

[ScooterTrash]

I've got spoked rims, y'all have a guy that can lace those after the hubs and rims get PC? Also, engine covers, no coating would get on the inside of them correct? Just don't want to have to worry about the motor sealing back up.

we dont respoke rims, but powder a whole crap load of them. Its not to hard to re-do yourself and there are a few vids on u tube. not to bad, I saw Mr. Unnassailable do his mini rims and true em good as new. or we can powder the whole rim, hub and spoke assembly all at once w/o you tearing them down.
To remove the spokes, you have to cut them out with small bolt cutters and replace with new ones as well.
either way, we can do 'em up, and also on the engine covers, we cover all gasket and mating surfaces with high heat tape to protect them. no problems, no worries there.:thumb:
Ready when you are.

[Texas94fs]

PC the spokes eh? Any problems with the coating cracking when they are tightened or anything like that? Would be easy for me just take em off before i need new tires have em done and then bam new tires, hopefully the shop wouldn't jack the powder coating right after i get it though hmmm

[ScooterTrash]

PC the spokes eh? Any problems with the coating cracking when they are tightened or anything like that? Would be easy for me just take em off before i need new tires have em done and then bam new tires, hopefully the shop wouldn't jack the powder coating right after i get it though hmmm

its always better to do them separately. and any decent shop can re-install w/o jacking it up, lest they pay to get them repaired.