PDA

View Full Version : pipe and can

MudBug
11-24-2008, 06:44 PM
If you pc a pipe and muzzy can will it just burn off or would stay looking good?:shrug:
Pyrofallout
11-24-2008, 06:47 PM
Pretty sure it will withstand the heat of a exhaust no prob. I have seen engine casings pc'd before and they looked just fine.
CaligoneTx
11-24-2008, 07:53 PM
U need to cut it first and shorten it like I showed you on mine.
bumblebee
11-24-2008, 07:54 PM
I think the can would be OK but I'm pretty sure the pipe would burn up the PC.
MudBug
11-24-2008, 07:55 PM
is there a wrap for the pipe. Its to shiney.
CaligoneTx
11-24-2008, 07:56 PM
hot temp spray paint.

I did a flat black on my katana. Rated to 3500 deg I think lol...


You can do the pink....
MudBug
11-24-2008, 08:11 PM
hot temp spray paint.

I did a flat black on my katana. Rated to 3500 deg I think lol...


You can do the pink....

ummmmm, no! How hard was it to cut the Muzzy down?
CaligoneTx
11-24-2008, 08:17 PM
not hard. I have this to work with:
MudBug
11-24-2008, 08:18 PM
Is that home or work? How much to cut it down?
CaligoneTx
11-24-2008, 08:19 PM
Tape off the outside cap, drill the rivots out, pull out the chamber w insultion on the cap. Measure, mark and cut more then you need. grind down the edge clean.

Install the cap partially, mark the cap holes, measure and drill after punch marking where the holes should be. Re-rivot the cap on(i turned mine to the side a bit.)
CaligoneTx
11-24-2008, 08:21 PM
stock muffler cut/welded w flatblack high temp paint:
http://i222.photobucket.com/albums/dd116/caligonetx/busa%20and%20mods/Kat.jpg

muzzy cut 6-8 inches on the outside so the mount wasn't effected, painted midpipe:
http://i222.photobucket.com/albums/dd116/caligonetx/busa%20and%20mods/100_1944.jpg
http://i222.photobucket.com/albums/dd116/caligonetx/busa%20and%20mods/100_227deleted
MudBug
11-24-2008, 08:23 PM
that looks good. How much to do it? lol
CaligoneTx
11-24-2008, 08:24 PM
A Saturday Im not working...(working this saturday)


I dont charge for fun stuff; and I fix BMW(cars) not bikes. Modifying is different lol
MudBug
11-24-2008, 08:25 PM
cool. just let me know. I may be able to take off for a emergency like this. lol
ScooterTrash
11-25-2008, 06:12 AM
or you can Powdercoat it high heat flat black and not worry with chips and scratches.
answer is: yes, if you use the correct powder (high heat powders) you can do exhaust systems, I do it all the time on car headers and bikes.