Pipe Bending

[MadseasoN]

Need some help here. I ordered a knockoff pipe for the XR70 but it doesn't fit. The bend angle is too high - meaning that the pipe is too close to the frame when mounted on the bike.

Where can I get the pipe bent?

[houseofpaint]

any muffler shop should be able to bend it.

[gixxa 123]

WHAT ABOUT CUTTIN THE PIPE U KNO ANYTHING BOUT THAT?

[H2447INTX]

if it need a little bend you can do it your self, if it needs sharp bend take it to a shop, shouldnt cost to much 20 buck i would think!

[RaZ]

most muffler shops wont have the dies to bend pipe that small.... may have to find an electrician with hydraulic bender

[soap4life]

hammer

[Silver Bullet]

hammer

Or he can just give it to you to play with for a day or two :laughing6 :laughing6

[Tango1300]

Fill the pipe full of Sand... cap the ends with rubber caps that you can get at home depot and then use a Conduit bender to bend the pipe. This way you can bend the pipe without it collapsing and will give you a smooth bend.

Hope this helps.